Quick Start Guide Serial to WiFi Adapter www.wifiandscales.com
$ db set /app/factory_preset 0
To check our parameters we type “db get” to list all parameters to check.
$ db get
PATH FLAGS SZ TYPE VALUE(S) INFO
---------------------------- ----------- -- ----- -------------- ----------
/wl/ssid NV 1 SSID my-wifi-net
/wl/key NV 1 STR my-key
/net/dhcp NV 1 BOOL 0
/net/ip NV 1 IP 192.168.2.10
/net/mask NV 1 IP 255.255.255.0
/net/gw NV 1 IP 192.168.2.1
/proxy/mode NV 1 BOOL client(0)
/proxy/baudrate NV 1 U32 9600
/proxy/ip NV 1 IP 0.0.0.0
/proxy/port NV 1 U16 2000
/app/mode NV 1 BOOL http(0)
/app/factory_preset NV 1 BOOL 0
/wl/key_type NV 1 U8 wpa(2)
/app/name NV 1 STR
/app/debug NV 1 BOOL 0
Note: the actual list is longer as it includes alarm and warning levels which are omitted here.
Satisfied with the result we enter the parameters into the flash with ”db store”
$ db store
We can now disconnect the WiFi Adapter from the serial port and DC power.
3.1 Restore factory settings
The WiFi Adapter can be returned to the configuration pre-set in manufacturing by following
these steps:
The reset button is located in the hole between the LEDs and DC jack.
Use a toothpick or another pin that fits the hole snugly.
Insert the pin straight into the hole and press the button for 5 sec.
The red and green led starts blinking simultaneously indicating that the unit is in factory
settings mode.
If the WiFi Adapter is in serial port configuration mode it is NOT possible to restore factory
settings with the reset button, the command line is used instead as shown below:
$ db set /app/factory_preset 1
$ db store
$ reset
Using the WiFi Adapter in Web server mode
The scale has to have the “Serial Port Mode” set to “0” = full duplex. How to do this is
described in the manual for the scale.
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales